General
Frequency Coverage MHz   (RX) 425.000-449.995  (TX) 425.000-449.995 MHz  Channel Spacing   5, 10, 12.5, 15, 20, 25KHz steps  Memory Channels   20 Channels + 1 Call Channel Memory  Antenna impedance   50 ohms unbalance  Frequency Stability   ±5 ppm  Microphone input impedance   2 kohm nominal  Signal Type   F3E (FM)  Power Supply Requirements   3.6V ~ 4.5V DC (4.5V standard with 3 AA batteries)  Current Consumption at 4.5V   Transmitting: Approx. 260mA  (High Power Receiving: Approx. 33mA Squelched)  Ground   Negative  Operating Temp. range   -10 to +60°C  Dimention w/o projection   2-1/6(W) x 4(H) x 1-1/10(D) Inches  Weight   Approx. 6.5oz. (Batteries Included)  Sub Audible Tones   Encoder Installed (50Tones)
Transmitter
Power output   High: Approx.340mW  Low:Approx. 50mW  Modulation System  Variable reactance FM  Max. Deviation  ± 5kHz  Spurious Emission  -60dB Or Under Below Carrier Level  Tone Frequency  67.0 to 254.1Hz (50 Selections)  Microphone  Electret Condenser  Operating Mode  Simplex/Semi Duplex 5KHz Steps Minimum Between 0-15.995MHz  CTCSS Encoder   Built-In And IncludedAs Standard
Receiver
Receiver System   Super Heterodyne Dual Conversion  Sensitivity   12dB SINAD : Less Than -15dBu at 445.000MHz  Squelch Sensitivity   Less Than -17dBu  Intermediate Frequency   1st IF: 23.05MHz  2nd IF: 450KHz  Selectivity  More Than +/- 7.5KHz at -6dB  Audio Output  More Than 100mW @ 10% THD  Speaker Impedance  8 ohms

Specifications
Frequency Range/	[LPD(VFO) mode]   TX: 433.06000~434.78000 MHz   RX: 433.06000~434.78000 MHz [PRM mode]   TX: 446.00625~446.09375 MHz   RX: 446.00625~446.09375 MHz
Modulation	F3E
Antenna Impedance	50Ω
Supply Voltage	3.0-6.0 VDC (DC-Jack), 2xAA Batteries, Li-ion pack
Current (approx.)	[Transmit]  [LPD(VFO) mode] : 0.20A  [PMR mode] : 0.45A [Receive] : 60mA st-by
Frequency stability	± 5ppm
Dimensions	57(W)x98(H)x27.9(D)mm Projecsions exclusive
Weight (approx.)	[DJ-S45CQS] - 164g (2xAA batteries inclusive) [DJ-S45CQL] - 170g (2xAA batteries inclusive)
Power Output (DC6.0V)(approx.)	[LPD(VFO) mode] : 10mW [PMR mode] : 500mW
Modulation	Variable Rectance
Max. Deviation	±2.5kHz
Spurious Emission	250nW or less
Mic. Impedance (approx.)	2kΩ
System	FM: Double-conversion super heterodyne
Intermediate Freq.	FM: 1st 21.7MHz, 2nd 450kHz
Sensitivity	-15dBu or less (12dB SINAD)
Selectivity	FM  -6dB: 6kHz or over  -60dB: 14kHz or less
AF Output	180mW or over (MAX) 150mW or over (10% Distorsion Factor 8Ω)
Spurious response	2nW or less